How Do You Refill A Drag Vape?

How Do You Refill A Drag Vape?

Before attempting to refill the vape juice in your device, you will have to dislodge the pod from your device. The pod will be magnetically secured to your device. So, separating the two should not be a major problem. Open the rubber seal flap on the pod's side and fill it with your e-liquid.

Halt for a moment before diving right into refilling the vape juice. If you need to replace your coil, now is the optimal time. When you want to change the coil, all you have to do is pull out the coil from the centre of the pod. This might be an easier feat for those of you who have nails. As for those who lack the proper grip to do so, you could try using a thin and long object that can help you.

Now that the coil has been replaced or newly installed, you can proceed to refill the vape juice of your device. The refill point is also located on the pod itself. Feeling around the edge at the bottom of the pod, feel for a rubber seal. Before opening the rubber seal, remember to keep your pod base up where the thinner end faces the ground. This prevents any leakages, which would waste vape juice and money.

Once you have screened through all the above precautions, you can open up the rubber seal. You will notice that there is a hole for you to insert the nozzle of your vape juice bottle so that the refilling can be done without any spillages. Note that you should be squeezing the bottle gently so that the liquid flows out at a controllable pace and does not gush out all over the pod.

Once you see that the liquid is reaching the brink of the pod, remember to prepare to stop squeezing the bottle and give way to some excess drops. Once this is done, remember to seal up the hole with the same rubber seal from earlier. Ensure that the plug is secured in place. You must practice patience and allow the coil to soak up the e-liquid thoroughly. Otherwise, you will find that there is not enough cloud of flavour to your puffs when you take a vape from your Drag vape kit.

Some other tips that you can take note of are that there is a slider located on the device under your pod that controls the airflow. You can make adjustments to that after refilling your drag vape. Allowing more outside air to enter the device can facilitate the absorption process. Additionally, if you require tips on where to obtain vape juice, they are easily available at most outlets.

There you have it, and we hope there was not much of a hitch when refilling your vape juice. If there are any problems, you can always contact the manufacturer. Also, after you’ve refilled your Drag vape, do remember to do a few test puffs to check!

If you want to learn more about Drag vapes, check out our blog on can Drag S Pro use PnP coils for more information.